|
|
|
 |
|
Place template 1" larger than the mat on the prepared
surface. |
|
|
|
|
|
|
|
|
 |
|
Prime the entire template area with ATM Permanent Primer.
This may be done by roller, brush or sprayer. |
|
|
|
|
|
|
|
|
 |
|
Permanent Primer must be thoroughly dry and firm before the
mat can be applied, Depending on temperature and humidity, this will take approximately 5
to 10 minutes. |
|
|
|
|
|
|
|
|
 |
|
Place the Warning Mat into position. |
|
|
|
|
|
|
|
 |
|
Tamp the Warning Mat in place with an instrument such as the ATM 19151 Tamper
Cart*.
|
 |
Special attention should be paid to the outside edges of the Detectable
Warning Mats to make sure they are firmly adhered to the surface. |
|
For large installations it is recommended the installer purchase a
specially designed ATM 19151 Tamper Cart. This will greatly reduce installation
time and insure a successful installation. |
|
|
|
|
|
|
 |
|
Depending on surface conditions and local and state
requirements included anchoring system may be used.
|
|
Refer to included diagram for proper anchor attachment, pre-drill holes
with 3/16" masonry bit and install anchor bolts. |
|
CAUTION: screw bolts to the top of the mat only. Over-tightening or
screwing bolts beyond this will damage the mat and void their warranty. |
|
|
|
|
|
|
|
|
|
 |
|
Open to traffic immediately. |
|
|
|
|
|
 |
|
|
For large installations it is
recommended
the installer purchase a specially
designed ATM 19151
Tamper Cart.
This will greatly reduce installation time
and insure a successful installation. |
| |
|
|
